BIG AIR CARBON FIBER INTAKE TUBE WITH MOLDED IN MAF
The best part of our Carbon Fiber Big Air is we kicked the cool factor up a notch and molded a 127mm MAF housing right in the tube. With no separate MAF housing or couplers air flow is fast and smooth.. Early testing shows this can be used with the stock MAF sensor all the way up to 750 RWHP and well beyond with a MAFia, SCT BA5000 or HPX sensor.
Includes our new roto molded heat shield to block engine heat at idle and low speed. It has two mounting points and a weather strip that seals to the hood and uses a large area to make sure the filter has tons of cool air.
60-90 RWHP is typical with this kit and our custom tune.
This puts most GT500’s at 495-515 HP at the rear tires. (500 HP is rated at the flywheel from the factory)
A JLT specific tune is required with this kit.
Real Prepreg Carbon Fiber. The best quality carbon fiber you can use!
The new design, detailed instructions and online video instructions helps make this an easy install.
•JLT Carbon Fiber Intake Tube
•5x9 S&B Powerstack Air Filter
•Roto molded Heat Shield
•HD Clamps & all needed hardware
AIR FILTER: OIL OR DRY
We use only the best air filters made by S&B to our specifications.
For years we only used oiled filters, but dry filter technology has been proven and is now a popular option.
Should I choose a Dry Disposable or Cotton Oiled Filter?
Since you are not sacrificing performance with either choice, the decision comes down to would you rather throw away the filter or clean it.
Comparable Airflow to oiled Cotton Filters with the same Great Protection. Last for up to 30,000 miles of highway driving. Extend the life of the filter using compressed air.
Oiled filters can last forever as long as you properly clean and re-oil it. See maintenance information below.
Blow-By Racing is not responsible for any prices changes, mis-mark items , or any other mis-printed items.